Autel MaxiDiag Elite MD701 Manuel d'utilisateur télécharger pdf (Page 80)

 The test is finished successfully.

 The test is stopped by the user.

 The test did not finish.

In the first condition, the tool will display an information screen as

“The operation was performed correctly. Put the vehicle on a

vehicle lift and check that the rear wheels are locked. Check that

the 'Electric parking brake on' message is display on the control

panel and that the LED illuminates on the control panel.”

In the second condition, the tool will display an information screen

as “Operation of the actuator test was stopped by the user. Press

„Cancel' to go back to the list of possible operations.”

In the third condition, the tool will display an information screen as

“The actuator test did not finish operating. Please perform the

following check: Read the faults to resolve any possible faults

relating to the electric motor or to the cables.”

IMPORTANT: Make sure that the components to be tested are

not physically damaged and are well assembled.

WARNING: Please stop repairing the components to be tested

before the test starts and keep a certain distance during the test.

8.3. ABS Maintenance

In the System menu (Figure 8.2), use UP/DOWN button to select

ABS to do ABS maintenance. The scan tool displays as below:

Figure 8.20

Diag. Menu

6. Read Codes

7. Erase Codes

8. Live Data

9. Active Test

10. ECU Information

6. Special Function

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 89 90

Pas de commentaire

Autel MaxiDiag Elite MD701 Manuel d'utilisateur Page 80