Autel PowerScan PS100 Manuel d'utilisateur

Table of Contents 1. SAFETY PRECAUTIONS AND WARNINGS ... 1 2. USING THE TEST TOOL ...

9 3. Test Applications 3.1 Voltage & Polarity Testing While the tool is in DC Voltage mode, contact the probe tip to a POSITIVE circuit. The re

10 While the tool is in Resistance mode, using the probe tip with chassis ground or the auxiliary ground lead, continuity can be tested on wires and

11  If the resistance value is greater than 200kΩ , the LCD will show “0L”. There is also another way to prove continuity of con

12 Figure 10 If the LCD readings are abnormal, there is a problem with this sensor. 3.4 Activating Components in Your Hand While the too

13 Figure 11 If the green LED went off at that instant or if the circuit breaker tripped, the tool has been overloaded. This could happe

14 voltage to the probe tip. This lets you check the function and orientation of the connector and trailer lights. (Figure 12) If the circ

15  The component is a very high current component(i.e., starter motor). If the circuit breaker is tripped, reset it by waiting for it to c

16 may proceed with further activation. (Figure 14) If the green LED went off at that instant or if the circuit breaker tripped, the tool has been ov

17 Observe the green LED. Depress the power switch forward then release. If the green LED went out and the red LED came on, this is not a tr

18  Follow the wire in the shorted direction and repeat this process until the short is located. 3.10 Red/Green Polarity LED The Red/Green Polarit

1 1. Safety Precautions and Warnings To prevent personal injury or damage to vehicles and/or the test tool, read this instruction manual first and o

19 4. Test Tool Specifications DC voltage range : 0-65V +1 digit Resistance range : 0 – 200 KΩ Frequency response of tone pass through 0Hz to 10

20 5. Test Tool Know-how 1) Is the PowerScan Probe Tester computer and air bag safe? The tool LED and LCD pull no more than 1 milliamp of curren

21 Figure 15  Make sure to install the switch straight and press until flush with casing. (Figure 16) Figure 16 It is recommended when buying you

22 6. Warranty and Service 6.1 Limited One Year Warranty Autel warrants to its customers that this product will be free from all defects in material

2 2. Using the Test Tool 2.1 Tool Description ① Probe Tip – Contacts the circuit or component to be tested. ② Head Lights – Illuminates dark wor

3 contacting a positive circuit. The GREEN Indicator lights when the Probe Tip is contacting a negative circuit. ④ LCD Display –Indicates test resul

4 6) Rugged blow molded case. 2.4 General Description The tool is the best electrical tester for reducing diagnostic time in all 6- to 30-volt vehic

5 With the tool connected, perform a quick self-test. The power switch is a momentary rocker switch located on the tool's body. Flanking the swi

6 contact the tip to the component. The arcing will take place at the tip instead of the contacts of the switch. 2.7 Circuit Breaker The tool is shor

7 While the tool in this mode, contact the probe tip to a circuit, then the LCD display will read the DC voltage with a resolution of 0.1 volt. (Figu

8 Figure 5 Tone On/Off While the tool in this mode, just do a quick press of the mode button to toggle the tone on or off. While quickly pressing (a