Table of Contents 1. Safety Instructions ... 1 1.1 Work Area Safety ...
9 remove the battery compartment and then remove batteries (Fig. 5). To install the batteries, remove the battery compartment and in
10 accessory and the imager head as shown in (Fig. 7), slip the end of the accessory over the flats of the imager head and then fix the accessory as
11 Fig 9 3.6 Monitor Charging Monitor Lithium-ion battery AC adapter Light Indicator Turned off Turned off Plugged in Charging: red light on
12 flashing Turned off Not installed Plugged in Red light flashing/ Green light on Turned on Not installed Plugged in Red light flashing/ Green light
13 Fig. 10 (4) Press Reverse button to control the direction of the real-time image. The real-time image will do a horizontal reverse or v
14 (7) Detachable 3.5" TFT-LCD wireless monitor allows for remote inspection up to 32ft (10m) from the measuring point (Fig.12).
15 Do not use the imager head and cable to modify surroundings, clear pathways or clogged areas. The handheld display unit is not
16 NOTE: Please check the following methods to avoid injury. FOR PIPES: If you suspect a metal pipe could contain a live electrical charge, have
17 repair personnel. Maintenance performed by unqualified repair personnel could cause injury. When maintaining, use only identical repl
18 5. Troubleshooting SYMPTOMS POSSIBLE REASONS SOLUTIONS Display unit is on, but does not show image. Cable connection is loose. Check if it
1 1. Safety Instructions IMPORTANT: To avoid electric shock, fire and/or personal injury or damage, please read this user’s manual carefully
19 Image too dim or too dark LEDs near camera require adjustment Use the roll switch to adjust brightness Monitor will not charge Cable are not accu
20 repaired by anyone other than the Manufacturer’s Service Center. 3) Autel shall not be liable for any incidental or consequential dama
2 oil, sharp edges or moving parts. If operating the tool in a damp location is unavoidable, use a ground fault circuit interrupter (GFCI) to prot
3 2. Description, Specifications and Tool Components 2.1 Description This premier Autel MaxiVideoTM MV301 digital videoscope features a detacha
4 Display resolution 320 x 240 Power supply Rechargeable Li-ion battery in monitor & 4 x AA batteries in camera Tested battery life 4-5 hours o
5 2.3 Accessories Included 1) Blow molded case 2) AC adapter 3) User’s Manual 4) Imager head and cable (16mm /8.5mm/5.5mm) 5) Magnet, hook and
6 1) Handheld Display Unit- The ergonomic tool with comfortable pistol grip design. 2) Cable Connector – Connects the handheld display unit t
7 2.5 Buttons and Controls Fig. 3 A. LCD Screen – Indicates test results. Backlit, 320x240 pixels display with LED lighting adjustment. B.
8 3. Installation 3.1 Battery Removal and Installation NOTE: If the power indicator light is blinking continuously, this reminds you to replace batte
Commentaires sur ces manuels